Saddle & SpokeCity & touring parts, Amsterdam

Tell us the numbers on your tyre. We’ll tell you what fits.

Tyres, tubes, brake parts and racks for city and touring bikes, sold from a workshop counter in Amsterdam Oost. Every part is listed with the sizes it fits, and the fit check tells you when one is wrong for your bike, and why.

Exploded drawing of a rear bicycle wheel: tyre, inner tube, rim tape, rim, hub with roller brake, and axle nut, laid out along the axle line.
ItemPartOn this wheel
1Tyre40-622, reflective sidewall
2Inner tubeDunlop valve, 32–47 mm
3Rim tape18 mm, covers the spoke holes
4Rim622 bead seat, 19 mm inner width
5Hub7-speed hub gear, roller brake
6Axle nut15 mm, nutted axle
Fig. 1 Rear wheel of a hub-gear city bike. Item 4 decides almost everything else on the list.

The two numbers that matter are already on your tyre

Inch sizes are names, and several different wheels share each name. The ETRTO size moulded beside them is a measurement. Find it before you order anything round.

Close-up of a tyre sidewall with 40-622 moulded in large figures and 28 x 1.50, 700 x 38C in smaller print.
40

Width of the tyre in millimetres, inflated. This is the number your frame and mudguards care about.

622

Bead seat diameter in millimetres. It must match the rim exactly. Not one millimetre of give.

Sidewall reader

Type what is printed on your tyre, in any of the usual forms.

What we fit most at the counter

The tyre most commuter bikes here leave the factory on, the one we’d tour on, and the rack that suits nearly every 26 or 28 inch frame.

All parts in stock

Three sizes that look the same and aren’t

Most of the parts people send back to us were ordered by name. Each of these pairs is sold under one label and will not swap.

Printed asActuallyWhat happens if you mix them
28 in622 or 635The modern rim is 622. Older Dutch roadsters with rod brakes use 635, sold as 28 x 1½. A 622 tyre will not stretch over a 635 rim, and a 635 tyre on a 622 rim comes off at the first bump.
26 x 1.50 / 26 x 1½559 / 584The decimal and the fraction mean different wheels, 25 mm apart in diameter. 26 x 1 3/8 is a third size again, 590, on older English and Dutch city bikes.
Any tube, “fits 28 in”6.5 or 8.5 mm holeA Dunlop or car valve needs an 8.5 mm hole in the rim. A rim drilled for Presta is 6.5 mm, and those valves will not go through it at all.

The full size guide, with every conversion we use

Or bring the bike, and we fit it while you wait

The counter and the workshop are the same room on the Czaar Peterstraat. Buy the part online and choose collection, or walk in with the bike. Most jobs below take under half an hour, and you pay for the part separately at the shop price.

A rear wheel with a hub gear and roller brake takes longer because the gear cable and brake arm come off with it. That is why it costs more, and why it is the job most people bring to us.

Workshop hours and booking
Tyre or tube, front wheelQuick release or nutted€10
Tyre or tube, rear, derailleur bike€12
Tyre or tube, rear, hub gearIncludes re-tensioning the gear cable€18
Brake pads, per wheelPads aligned and toed in€10
Roller brake grease top-upGrease included€8
Rack or front carrier fitted€15

From the counter

I came in for a 47 mm touring tyre and left with the 40. They measured my rim at 17 mm and told me the wider one would roll in corners. Two winters on it, no flats.
Marieke D. commutes Zeeburg to Zuidas
My grandfather’s Gazelle needed tyres and three shops sold me 622s. The fit check said 635 in one line. Here was the only place that stocked them.
Joost V. rides a 1974 roadster
The squeal turned out to be dry grease in the roller brake, not worn pads. Nine euros fifty and five minutes, instead of the pads I was about to order.
Priya S. cargo bike, two children, one hill